The ЧДБ RX 150 spiral dipole antenna is a receiving spiral dipole antenna from the Ukrainian manufacturer ЧДБ (Cherkasydronbud) for the onboard RX receiver in 150 MHz radio control systems (MIL ELRS, TX+RX 150 kits). Central frequency 150 MHz, gain 2.15 dBi, length 20 cm.
Important: the spiral dipole antenna for RX 150 must be installed only in vertical polarization — otherwise, the range and stability of communication will sharply decrease. Bandwidth with VSWR < 1.5 — 3 MHz; linear polarization, 50 Ohm, IPEX connector.
Key Features
- Type: spiral dipole, receiving antenna for RX.
- Operating range 150 MHz (center frequency; ЧДБ systems 150–153 MHz).
- Gain 2.15 dBi, impedance 50 Ohm.
- Bandwidth (VSWR < 1.5): 3 MHz.
- Polarization: linear (mandatory vertical installation).
- Antenna length: 20 cm; weight with mast: 33–35 g.
- IPEX connector; mount and mast included.
Key Advantages
- Standard for TX+RX 150: included in Yagi + spiral RX kit (up to 43 km according to ЧДБ data).
- Compactness: length 20 cm, low weight on the drone frame.
- Precise tuning to 150 MHz: low VSWR in the 3 MHz band.
- Compatibility with RX Mk4 150: alignment with ЧДБ firmware and receiver.
- ЧДБ in-house production: proven option for the MIL ELRS military line.
Areas of Application
- Onboard receiver RX Mk4 150 MIL ELRS on FPV/reconnaissance UAVs.
- ЧДБ TX+RX 150 MHz kits (with spiral RX option).
- Replacement or additional RX 150 antenna in the field.
- Ground control stations and platforms with a 150 MHz control channel.
Package Contents
- Spiral dipole antenna RX 150 (20 cm length).
Technical Specifications
| Parameter | Value |
| Product type | Receiving antenna (spiral dipole) for RX |
| SKU | 945 |
| Brand | ЧДБ (Ukraine, in-house production) |
| Antenna type | Spiral dipole, receiving |
| Frequency range | 150 MHz (center; compatibility 150–153 MHz) |
| Bandwidth (VSWR < 1.5) | 3 MHz |
| Gain | 2.15 dBi |
| Polarization | Linear (vertical installation only) |
| Impedance | 50 Ohm |
| Connector | IPEX |
| Length | 20 cm |
| Weight | 33–35 g (including mast) |
| Package contents | Antenna; |
Operating Warnings
- Install the RX 150 spiral dipole antenna only in vertical polarization — this is a mandatory manufacturer requirement; horizontal or tilted installation critically degrades reception.
- Secure the mount and mast to the frame so that the antenna does not interfere with the propellers and does not vibrate during flight.
- Do not bend or damage the cable near the IPEX connector.
- Ensure that TX and RX operate in the 150–153 MHz range — VSWR increases outside the 3 MHz band.
- Orient the mast perpendicular to the frame plane (vertical relative to the ground in a typical drone configuration).
The ЧДБ RX 150 spiral dipole antenna is a standard onboard solution for 150 MHz: 2.15 dBi, ready-to-mount on the frame, and a strict requirement for vertical polarization for maximum range as part of ЧДБ MIL ELRS.
For other products in this category, see the Military Dipole Antennas section.
There are no reviews for this product, be the first to leave your review.
No questions about this product, be the first and ask your question.