Impact-resistant protective automotive tint film Armolan ST Black 05 4mil (100µm), width 1.52m, length: cut to size (1 sq.m./0.66 lin.m.)

Impact-resistant toning car film against explosion ST Black 05 - 4mil (color: black) - a series of combined films that combines an impact-resistant base 100μm thick and classic toning. The color of the film is obtained due to sputtering of metals between layers of polyester. This is a unique series from the premium brand ARMOLAN Professional Window Films (USA).

Main advantages:
- protect the car interior from burning, block up to 99% of UV radiation;
- resistant to mechanical actions, have an outer layer that protects against scratches;
- antistatic, do not electrify;
- tensile strength 19 kg/cm

Width 1,524 m., any number of linear meters can be cut!

The ST Black series is an innovative technology of high impact-resistant film forming. The film reflects not only the rays of the bright sun, but also protects against penetration into the car interior through the glass.

Installation guide for sun-protective and impact-resistant film

You will need:

• Utility knife (very sharp)

• Scraper — for cleaning glass

• Water sprayer

• Squeegee or a plastic card wrapped in a thin cloth

• Soap solution (optional): 5 drops of liquid soap or shampoo per 1 liter of water

Installation steps:

Step 1: Film preparation

• Measure the glass dimensions.

• Cut the film with a 2–3 cm margin at the edges.

Step 2: Glass preparation

• Wash the glass thoroughly with a cleaning agent.

• Remove dust, dirt, stains, and grease with a scraper.

• Then generously wet the glass with clean water from a sprayer (or soap solution for easier film sliding).

Step 3: Film preparation

• Remove the protective layer from the film.

• Wet the adhesive side of the film with water or soap solution.

Step 4: Application

• Apply the film (wet adhesive side) to the wet glass.

• Wet the outer face of the film with water to avoid scratches while smoothing.

Step 5: Smoothing

• With a squeegee or a card wrapped in cloth, squeegee out air and water from under the film.

• Move from the center to the edges, working only on a wet surface.

Step 6: Trimming

• After smoothing, carefully trim excess film with a sharp utility knife along the glass edge.

⚠️ Important tips:

• Work in the shade or in a cool room — direct sunlight makes installation harder.

• Keep the film wet during all steps — this prevents scratches.

• The film can be removed and repositioned while it is still wet.

Specifications

Armolan, impact-resistant protective, impact-resistant protective automotive, impact-resistant protective tint, impact-resistant protective film, Impact-resistant, lin.m.